ISTRUZIONI PER L’USO
4
87-900-856-01 (B)
MESSAGGI DI ERRORE
In alcuni casi di guasto la circuiteria di autodiagnosi del
controller presenta alcuni messaggi di errore elencati
nella tabella seguente.
I messaggi di errore sono presentati solo se è installata
l'opzione "hand held terminal".
MESSAGGIO
DESCRIZIONE
AZIONE CORRETTIVA
CHECK CONNECTION
TO PUMP
Malfunzionamento nel collegamento tra
pompa e controller.
Verificare che il cavo di collegamento tra
pompa e controller sia ben fissato da
entrambe le estremità e non sia interrotto.
Premere due volte il pulsante START per
riavviare la pompa.
FAULT: OVERTIME SX
Durante l'avvio della pompa nel modo
"soft start", la pompa non ha raggiunto la
velocità prevista ad ogni passo entro 15
minuti. (X può valere da 0 a 9 ed indica il
passo non superato).
Verificare che il sistema non presenti delle
perdite.
Premere due volte il pulsante START per
riavviare la pompa.
FAULT: PUMP OVERTEMP.
La temperatura del cuscinetto superiore
o della pompa ha superato i 60 °C.
Attendere che la temperatura ritorni al di
sotto della soglia.
Premere due volte il pulsante START per
riavviare la pompa.
FAULT: CONTROLLER
OVERTEMPERATURE
La temperatura del trasformatore del
controller ha superato i 90 °C.
Attendere che la temperatura ritorni al di
sotto della soglia.
Premere due volte il pulsante START per
riavviare la pompa.
FAULT: TOO HIGH L0AD
Durante il funzionamento normale (dopo
la fase di avvio) la corrente assorbita
dalla pompa è maggiore di quella
programmata (1,5 A).
Verificare che il rotore della pompa abbia la
possibilità di ruotare liberamente.
Premere due volte il pulsante START per
riavviare la pompa.
FAULT: SHORT CIRCUIT
Durante il funzionamento normale (dopo
la fase di avvio) la connnessione di
uscita è in corto circuito (corrente di
uscita maggiore
di 2,2 A).
Verificare i collegamenti tra pompa e
controller.
Premere due volte il pulsante START per
riavviare la pompa.
FAULT: R2 DELAY OVER
La velocità di rotazione della pompa è
scesa al di sotto del valore di soglia
programmato, il controller è in OFF ed
R2 è diseccitato.
Verificare che non ci siano eventuali
perdite nel sistema, o verificare le
condizioni di carico del gas.
Applicare al pin
b8
del connettore
P17
il
segnale di reset per riavviare la pompa.
OVERVOLTAGE
Si è verificato un guasto nella sezione di
alimentazione del controller, o il
controller ha ricevuto un segnale spurio.
Premere due volte il pulsante START per
riavviare la pompa.
Se il messaggio si ripresenta rivolgersi in
Varian per la manutenzione.