![background image](http://html2.mh-extra.com/html/varian/969-9447/969-9447_instruction-manual_4798124087.webp)
TECHNICAL INFORMATION
8
3 87-900-905-01 (
I
)
•
Press the PUMP CURRENT push-button and the
display shows
L
O W E R
B E A R I
N G
T
2
S E N S O R :
O F
F
Detection of the pump’s lower bearing temperature. OFF
will always be indicated if there is no sensor on this
bearing.
and then:
S O F
T
S T
A R T
M O D E
S E L
E C T
I
O N :
X X X
where:
XXX
= YES or NO.
If YES is selected, the Soft Start mode allows the pump to
rump-up the Normal speed within ten steps.
When NO is selected, the Soft Start mode is deselected
and the rump-up of the pump will be done within 360
seconds.
The controller is factory set to YES.
NOTE
The Soft Start mode may be deselected/selected only
when the pump is stopped.
•
Press CYCLE NUMBER push-button to select YES or
NO
S O F
T
S T
A R T
M O D E
S E L
E C T
I
O N :
Y E S
•
Press PUMP CURRENT push-button and the display
shows:
W A T
E R
C O O L
I
N G
?
N O
If necessary press CYCLE NUMBER to select YES or NO.
The controller is factory set to NO.
•
Enter the selection by pressing the PUMP CURRENT
push-button, and the display shows:
F R O N T
/
R E M O T E
/
S E R
S E L E C T
I
O N
:
X X X X X X
where:
XXXXXX
= means the word FRONT. REMOTE, or
SER depending on the last selection.
The controller is factory-set for FRONT panel operation.
SER will only be displayed if the optional serial card is
installed.
Содержание 969-9447
Страница 2: ...Turbo V 1000 ICE Controller...
Страница 93: ...89 87 900 905 01 I MAINTENANCE...