Vari Hurricane F-600, Инструкция по эксплуатации, Страница: 12 / 41

F-600
12
the pin differential in wheels). Start walking simultaneously with the machine start,
adapting your walk pace to the direction and speed of the machine.

Be prepared when the machine starts moving with a little jerk.
•
Travel back: Move the gear-shifting lever to the „R“ position. Then press the upper red
sheet-iron lever on the left handrail down to the grip and the machine starts moving in
reverse direction (sometimes with a little delay due to the run-out of the pin differential in
wheels). Start walking simultaneously with the machine start, adapting your walk pace to
the direction and speed of the machine.

Be very careful when moving backwards with the machine!

Start driving with approximately ½ of maximum engine revolutions if you want to
travel backwards. After the machine is in motion, set the engine revolution on the
level, which ensures that your walking pace is still safe.
Figure 4: Handlebars and control levers
Lever positions of engine speed
setup
STOP MIN
MAX CHOKE
Note:
All four main positions of engine speed adjustment lever are arrested by means of a
simple system (dent/rib) in the lever body.
5.6 Machine stop.
5.6.1 Stopping on the plain
If you wish to stop the machine travel, release the lever on the left handlebar grip. The
machine will stop moving but the blade will still turn. The cutting blade drive will be
switched off after release of the lever on the right handlebar grip. The safety brake will stop
the blade.

Prior to carrying out any activities in the near vicinity of the machine, switch off the
engine and wait until the cutting blade stops! Always switch the engine off before
leaving the machine!

Never let the engine running at maximum speed or idling with the cutting blade
drive clutch released and with the released clutch of travel wheels drive for a long
Blade and brake drive clutch lever
Accelerator lever (engine speed adjustment)
Leading wheels adjustment lever (cutting height)
Gear-shifting lever
Lever of
machine travel
clutch and
automatic brake