Vari Lite VLX3, Руководство пользователя

Страница: 32 / 98

VARI
❋
LITE - VLX3 W
ASH
L
UMINAIRE
U
SER
’
S
M
ANUAL
16 17 December 2012 02.9703.0001 A
Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows (refer to Figure 2-5 ):
a. Connect one end of cable to luminaire handle.
b. Loop at least once around truss/pipe and attach other end of cable to opposite handle.
Step 4. Connect power and data cables according to procedure given in “Connecting Data and
Power” on page 17 .
WARNING: DO NOT connect or disconnect energized power cable at fixture (under load). Turn off
circuit breaker (or completely de-energize circuit) before connecting or disconnecting power cable at
fixture. Power is only removed from the fixture by disconnecting power cable from source or turning
off source circuit breaker.
Step 5. Be sure pan and tilt locks are disengaged (refer to “Luminaire Overview” on page 7 for
details) to allow full head and yoke movement.
Figure 2-5: Hanging Configuration and Dimensions
21.50 in
546.10 mm
18.88 in
479.56 mm
23.36 in
593.34 mm
21.50 in
546.10 mm
3.00 in
76.20 mm
(lens extended)
Safety Cable :
Recommended for hanging installations.
May be required by local codes. Safety
cable is sold separately.
Enclosure can be oriented in either
direction. See
Figure 2-3
for details.
NOTE: The enclosure handles
were tested and are in compliance
(for safety cable anchor points) of
the following safety standards:
- IEC / EN 60598-2-17.6.6
- UL1573
Enclosure Handles
(see note)