Vari Lite VL2000, Руководство по обслуживанию

Страница: 40 / 190

VARI ❋ LITE ® - VL2000™ S
POT
L
UMINAIRE
S
ERVICE
M
ANUAL
2 2 2 4- Ma rc h- 2 0 04 0 2 . 9 6 7 3 . 0 0 1 0 D
Front Assembly Removal
This procedure may be necessary to gain access to other components.
Tools:
Screwdriver, #2 Phillips, long handle
To remove and re-install front assembly:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. At head cover, turn two captive screws one-quarter turn and remove cover. (It
will remain attached by tether.) Figure 2-8 .
Step 3. Remove front nose cover by removing two 10-32
×
1/2" PPB screws (one on
each side).
Step 4. At front assembly, disconnect wire connectors from rotating gobo index
motor and rotating gobo wheel motor.
Figure 2-8: Front Assembly Removal
Step 5. At junction connector, disconnect edge motor and zoom motor wires.
Step 6. Face head nose upward. At front of bulkhead, using #2 Phillips long handle
screwdriver, remove four 6-32 X 3/8" PPB screws, and pull front assembly
partially out of head assembly.
Step 7. At rear of bulkhead, disconnect wires from rotating gobo sensor PCB.
Figure 2-9 .
Captive Screws
10-32
×
1/2” PPB Screw (2)
6-32
×
3/8” PPB Screw (4)
Wire Connector
Junction Connector
Route wiring harness here
Removable Cover
Front Nose Cover