SPIKE SPOTLIGHT
Power
3 | 5 | 10 Watts
unios.com
Page
1/4
Emerald
unios.com
Page
4/4
Mini
ESPI0003
Small
ESPI0005
Medium
ESPI0010
Base
Codes
Edition 2.6.23 |
Product design and technical data may be subject to change
Edition 2.6.23 |
Product design and technical data may be subject to change
Install Person/s
1x
Sizing Variations
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
CAUTION
– This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
Material
Aluminium
IP Rating
65
Parts
1x Allen Key
Class III
24V DC
B
C
A
D
All measurements are in millimetres.
ESPI0003
ESPI0005
ESPI0010
Product Code
A
80
100
B
Ø 50
Ø 63
C
70
78
D
56
80
110
Ø 75
86
92
Cleaning
Warning: Before cleaning, disconnect from
mains supply and allow luminaire to cool.
1
2
2x Heatshrink
Solder Joiners
Spike Height
169
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applications on
the luminaire or chemical contact via installation will
cause corrosion of the surface of the luminaire and will
void the warranty.
Ambient Conditions
Recommended to install in an
ambient temperature <35°C.
