Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
T: 00352/26908036 – F: 00352/26908040
XM-1010
2.Begin grinding and contact the work surface with enough down force to keep the grinding head flat against
the surface.
3.The U-joint in the grinding head will allow the grinding wheel to follow the contours of the work surface.
MOUNTING THE BAIL HANDLE:
1.Loosen the 2 thumb screw(05) and remove the clamp cap(04).
2.Place the handle in the desired position on the column.
3.Clamp the handle in place by replacing the clamp cap and tightening the 2 thumb screws.
MAINTENANCE
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air.All plastic parts should be cleaned with a soft
damp cloth.NEVER use solvents to clean plastic parts.They could possibly dissolve or otherwise damage the
material.
Wear safety glasses while using compressed air.
Clean the vacuum swivel connctor as too much dust will keep it from turning freely.
THE CARBON BRUSHES
The carbon brushes are a normal wearing part and must be replaced when they reach their wear limit.
NOTE:Checking and replacing the carbon brushes should be entrusted to a qualified service center.
The carbon brushes furnished will last approximately 50 hours of running time or 10,000 on/off cycles.
Replace both carbon brushes when either has less than 1/4’’ length of carbon remaining. To inspect or
replace brushes, first unplug the machine and lay it on its side. Remove the 3 screws to remove the left and
right motor rear bracket halves. Unscrew the two Carbon Brush Holders and remove the Carbon Brushes.
NOTE
:When putting the Carbon Brushes back into the Carbon Brush Holders it is essential that both flanges
go back inside the holder.
NOTE
:To reinstall the same brushes, first make sure the brushes go back in the way they came out. Otherwise
a break-in period will occur that will reduce motor performance and increase brush wear.
Replacing is the reverse of removal.
When replacing all covers, take great care that all wires are in place and not in a position to be pinched when
they are retightened. It is recommended that, at least once a year, you take the tool to an Authorized Service
Center for a thorough cleaning and lubrication.
If the replacement of the power supply cord is necessary, this has to be done by the manufacturer or their
agent in order to avoid a safety hazard.
