24
Checking the Flame
Refer to Fig.26 below (side view of grill) for where to check the flame after the grill
is lit. Make sure you have a stable, mostly blue flame.
Fig.26
Air Shutter Adjustment
The gas burner shutters are adjusted at the factory for your convenience. The
settings are: (a) 1/4 in. open for LP gas.
If you desire to fine tune your shutter adjustment (or if your flame is
more yellow rather than blue), please follow this procedure.
WARNING: Do not touch burner after adjustments. The burner is hot.
a.
The shutters are located on the end of the gas burners underneath the
firebox. See Fig.27.
b.
Loosen the air shutter screw.
c.
Light the burner to be adjusted.
d.
With a protected, gloved hand, fine tune the air shutter until a stable,
mostly blue flame is observed through the flame observation hole on
each side of the firebox. Acceptable flames are shown in Fig.34.
e.
Tighten the air shutter locking screw enough to hold the shutter in
place.
f.
Repeat procedure on other burners.
(a)
(b)
Air Shutter
Fig.27 Air Shutter
(c)
Fig. 28
Acceptable Flame only (a)
