This warranty does not cover cosmetic damage or damage due to acts of God, accident, misuse,
abuse, negligence, commercial use, or modification of or to any part of the Product. This warranty
does not cover damage due to improper installation, operation, or maintenance. This warranty is
limited to the original purchaser and is not transferable. In no case shall our company’s liability
exceed the original cost of the purchased product and will not cover consequential, incidental or
collateral damage. Our company reserves the right to inspect any and all equipment involved in a
warranty claim. Repair or replacement decisions are at the sole discretion of our company. Further,
our company reserves the right to change or modify this warranty without notice.
As our company has no control over use, setup, final assembly, modification or misuse, no liability
shall be assumed nor accepted for any resulting damage or injury. By the act of use, setup or
assembly, the user accepts all resulting liability.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE
REMEDY OF THE CONSUMER.
If you as the purchaser or user are not prepared to accept the liability associated with the
use of this product, you are advised to return this product immediately in new and unused
condition to the place of purchase.
AL50401 Fuselage for 50cc Edge 540
AL50402 Fiberglass Painted Cowling for 50cc Edge 540
AL50403 Canopy for 50cc Edge 540
AL50404 Rudder for 50cc Edge 540
AL50405 Left Wing Panel w/ Aileron for 50cc Edge 540
AL50406 Right Wing Panel w/ Aileron for 50cc Edge 540
AL50412 Left Stabilizer w/ Elevator for 50cc Edge 540
AL50413 Right Stabilizer w/ Elevator for 50cc Edge 540
AL50416 Landing Gear for 50cc Edge 540
AL50417 Wheel Pants for 50cc Edge 540
AL50420 Wing Tube for 50cc Edge 540
AL50421 Stabilizer Tube for 50cc Edge 540
AL50422 Decal Set for 50cc Edge 540
Contents of Kit
2
19
Control Throws
Correctly balancing an aerobatic model is critical
to its performance and flight characteristics.
Checking the balance on this model is best done
with two people.
Measure back 30%-33% of the whole wing root’s
length from the leading edge and mark the CG
range with a felt-tipped pen at the wing tip. This is
the recommended center of gravity (CG) range.
Step 1
Recommended Center of Gravity (CG)
A 7-channel or greater computer radio is highly recommended. This allows the following features:
• Mixing the right aileron to the left aileron (flaperon mix)
• Electronically adjustable aileron differential
• Mixing the right elevator to the left elevator (dual elevator mixing)
• Independent travel and trim adjustments of each elevator half
• Mixing the right rudder servo to the left rudder servo (not required when using a single rudder servo)
When you use a 7-channel or greater computer radio, each servo is plugged into its own separate
channel. Consult your radio manual for specific details on hookup and programming.
Radio Setup
20 up
20 down
°
°
40 up
40 down
°
°
15 up
15 down
°
°
26 left
26 right
°
°
40 up
40 down
°
°
43 left
43 right
°
°
Standard
3D
Standard
3D
3D
The following is our recommended control throws for your reference.
Standard
Elevator
Rudder
Aileron
