Vantec NexStar-3 MX, Руководство пользователя

Страница: 14 / 40

12
Installation
1.Adjust the switches as shown in Figure G.
Turn on the power and press the "adjusting key"
button. When the "Raid 1" on the front panel
is lit, Raid 1 Mode is active and complete.
2. The rebuilding period:
When you use Raid 1 for the first time, please
format the two hard disks in advance.
Estimated rebuild time is around 1 hour for every
100GB. When it is rebuilding, the HDD1/ HDD2
lights will flash. When the HDD1/HDD2 lights
become solid and stop flashing, this will indicates
rebuilding of the hard drive is complete.
1. When you set up Raid 1 Mode, we suggest you
use two hard disks of the same brand and capacity.
2. The default setting for first time use is set to copy a
mirror image of hard drive1 to hard drive 2.
(The first hard drive is behind the USB/eSATA port)
3. If RAID 1 is already set and running, any new hard drive
that is inserted/installed will be rebuilt to the already
installed hard drive.
4. When changing to a new hard drive, rebuilding time
is necessary.
5. When Raid 1 is set, HDD/HDD2 should both flash.
However if only one is lit while the other is off, this might
mean the other hard drive may not be functioning or
connected properly.
6. When the hard drive are finished rebuilding, the light of
the copied hard drive will flash.
7. If there is any pre-existing data on the copied hard drive,
the previous data will be overwritten by the information
from the hard drive that is being mirrored.
Setting RAID 1 Mode：
NOTE :
( Figure G )
( Figure G )
( Figure H )
Adjusting key