Vante SEBRA 2605, Руководство по эксплуатации

Страница: 15 / 32

P/N VT-108732-US, Manual revision: C
3-
3
Sealing Head Operation
Figure 3-2, Incorrect Technique for Holding the Tubing
Note: When the Sealing Head is operated, a minor arc discharge may occur be-
tween the sealing jaws.
Note: The Power Source is equipped with a thermal protection switch to prevent
the equipment from becoming damaged. If thermal cutout is reached, the power
source will not work for several minutes until the temperature of equipment low-
ers.
Warning: The Power Source is designed for rapid sealing applications; however,
extreme heavy duty use may result in thermal build up in the jaw area which
can cause hemolysis, poor seal quality or tubing ruptures. If you should
experience these problems, reduce the rate of sealing, as necessary, or allow for
periods of rest for the Sealing Head.
Caution: Never trigger the jaws when non RF reactive materials are in the sealing
region, or if the RF power source is not connected and turned on. Damage to the
jaws and poor Sealing Head operation may result.
3. The seal is completed in approximately one second, as indicated when
the sealing jaw retracts. Another seal cannot be made until the sealing jaw
fully retracts and the seal trigger has been completely released. To make
another seal, lift the tubing up to release the trigger and push the tubing
to the next seal position (see Figure 3-3, Repeating the Seal Process).
4. Activate the seal trigger to either the right or left, but for best results, move
the completed seals to the left (while facing the jaws) to avoid their inter-
fering with the seal trigger.