5
Connect the air lines from the handheld sealer to the INSERT and
RETRACT ports on the generator. See Figure 2.1
2.3.2.
Connect the coaxial cable from the sealing head to the BNC port (RF Output)
on the generator. See Figure 2.2.
2.3.3.
Connect the 4-pin plastic connector on the control cable assembly from the
sealing head to the RF generator’s AUX port. See Figure 2.1.
Figure 2.5 Model 3806MOD (3807MOD is the large size version) midsize tube sealer
2.4.
Power On
2.4.1.
Switch the power switch to ON ( ). See Figure 2.2
2.4.2.
The LCD screen and the exhaust fan activate.
NOTE:
Transistor electronics allow the RF generator to start operating as soon as it is
powered on; there is no warm-up period.
If the generator fails to power on, refer to section 4.2.
2.4.3.
The LCD screen displays the device name, model number, and software
version. After a short delay, the system enters an idle state. The LCD screen
says “Ready.” See Figure 2.6.
Figure 2.6 LCD screen, idle state
NOTE:
If the LCD screen says, “Not Ready,” the generator cannot be triggered.