EZCT-2000 USER’S MANUAL
REV 3
12
3.3 Performing
Tests
3.3.1. Entering Test Record Header Information
You can enter the test record header information before performing tests. The record header
includes identifying information such as the company, station, circuit, model number, etc. Once
the header information has been entered, it will apply to all subsequent test records. To enter
the header information:
a.
When the unit is turned on and the firmware has been loaded, you will be presented
with the “START-UP” menu as shown below:
Press the
[2]
key (
SETUP
).
b.
The following screen will be displayed:
Press the
[1]
key (
RECORD ID
)
c.
The following screen will be displayed:
Type the company name using the alpha-numeric keypad.
When pressing a key, the corresponding number on the key will be displayed first.
Pressing the key again will display the first letter on the key. Pressing the key again will
display the second letter on the key. For example, to type the letter “A”, you must press
the
[2]
key twice. To erase the character at the cursor position, press the
[CLEAR]
key.
Press the
[PAPER
∧
Contrast]
key to move to the next character. Press the
[PAPER
∨
Contrast]
key to move to the previous character. Press the
[ENTER]
key when you
are done typing the company name.
COMPANY:
↑
/
↓
TO POSITION
“ENTER” TO ACCEPT
1.
RECORD ID
2.
PRINT RECORD
3.
RESTORE RECORD
4.
NEXT PAGE
1.
RUN TEST 09/24/09
2.
SETUP 08:20:19
3.
TEST PLANS
4.
DIAGNOSTIC
Содержание EZCT-2000
Страница 25: ...REV 3 EZCT 2000 USER S MANUAL 21 Figure 6 Typical EZCT 2000 Tabulated Report Printout ...
Страница 33: ...REV 3 EZCT 2000 USER S MANUAL 29 Figure 9 Typical Internal Test Record Directory Printout ...
Страница 39: ...REV 3 EZCT 2000 USER S MANUAL 35 Figure 10 Typical EZCT 2000 Flash EEPROM Test Plan Directory Printout ...
