Vanguard 25E300, Руководство по ремонту

Страница: 75 / 104

Air Cleaner Assembly - High Mount - Installation
1. Prior to assembly and installation, make sure that all
mating and gasket surfaces are clean, dry and free from
contamination.
2. Install the new air cleaner base gasket onto the
alignment pins of the flange. Make sure the orientation of
the gasket matches the profile of the air cleaner flange.
See Figure 14.
14
3. Install the air cleaner base with gasket onto the throttle
body mounting studs. When installing the air cleaner
base, the top mounting flange must be located
underneath the ignition coil heat shield.
4. Start by hand the two air cleaner base to throttle body
fasteners ( B , Figure 13). Tighten to 40 lb-in (4.5 Nm).
5. Start by hand the upper air cleaner fastener ( A , Figure
12). Tighten to 95 lb-in (10.7 Nm).
6. Install the valve cover breather hose onto the air cleaner
base port ( A , Figure 13).
7. Install air cleaner into air cleaner base.
8. Install air cleaner cover. Turn clockwise by hand the two
air cleaner cover fasteners until snug.
Air Cleaner Assembly - Low Mount - Removal
1. See Front Cover Panel - Removal .
2. If servicing the air filter, unclip the air cleaner
cover retaining clips and remove cover from air cleaner
base.
3. Remove air filter from air cleaner base and inspect.
Clean or replace as necessary.
4. Remove the valve cover breather hose from the air
cleaner base port ( A , Figure 15).
15
5. Remove the lower air cleaner support bracket fastener
( A , Figure 16).
16
76 vanguardpower.com
Not for
Reproduction