Vanco VPW-280799, Руководство по эксплуатации продукта

Страница: 11 / 32

www.vanco1.com
888.769.4156 11
INDEX SETTING DETAILS INDEX SETTING DETAILS INDEX SETTING DETAILS INDEX SETTING DETAILS
1 0db/0db 9 16db/0db 17 23db/0db 25 26db/0db
2 0db/-3db 10 16db/-3db 18 23db/-3db 26 26db/-3db
3 0db/-6db 11 16db/-6db 19 23db/-6db 27 26db/-6db
4 0db/-9db (default) 12 16db/-9db 20 23db/-9db 28 26db/-9db
5 10db/0db 13 19db/0db 21 25db/0db 29 27db/0db
6 10db/-3db 14 19db/-3db 22 25db/-3db 30 27db/-3db
7 10db/-6db 15 19db/-6db 23 25db/-6db 31 27db/-6db
8 10db/-9db 16 19db/-9db 24 25db/-9db 32 27db/-9db
5. RST menu
Press “RST”, all of the settings will be reset to the default settings.
INFO MENU
NOTE: Red dot indicates that the corresponding RJ45 output port is in single output mode. Details please see the attached
CD-ROM about RJ45 output mode switch instructions.
Press “MS”- View the current status of matrix
Press “M1” - View the pre-existing state of matrix (Model 1)
Press “M2” - View the pre-existing state of matrix (Model 2)
Press “M3” - View the pre-existing state of matrix (Model 3)
Press “EQ” - View the current EQ setting status of matrix
NOTE: If the touch screen becomes insensitive, calibration is necessary.
Touch screen calibration method:Press the panel button “Setting” in the home menu status, holding until the following prompt
appears (about 4 sec).
Press the symbol’s center, until the one disappears and another symbol appears, and press its center again until the end of
the calibration—OK or Failure. If the calibration fails, please confirm whether the symbol’s center was aligned, then try again.
When finished with the calibration, press the panel button “Setting”, holding until exiting the calibration menu (about 4sec)