Vanco Evolution EVEXHDB3, Руководство пользователя

Страница: 8 / 20

www.vanco1.com 800.626.6445 8
PANEL DESCRIPTIONS
1. Power LED: Illuminates when the unit is powered on
2. Link LED:
Light on: Transmitter and Receiver are connected and communicating
Light flashing: Transmitter and Receiver are in Low Power Mode (check cabling, home-run cabling should
be utilized with no coupling points)
Light off: No connection between Transmitter and Receiver
3. Video LED
Light on: The video is encrypted and able to be passed to Receiver
Light flashing: The video is not encrypted
Light off: No HDMI input signal detected
4. ARC LED:
Light on: The device is switched to the ARC mode and will receive ARC signals from an ARC equipped
display, and will pass signals via the Cat6/6a/7 cable to the Transmitting unit
Light off: The device is switched to the SPDIF mode
5. SPDIF LED
Light on: The device is switched to the SPDIF mode. In this mode, the optical input on the Receiving unit
will be passed to the Transmitting unit, and then can be broken out via the SPDIF out or HDMI loop-out
Light off: The device is switched to the ARC mode
6. SELECT Button: Used for switching between the ARC and SPDIF modes
7. DEVICE/HOST USB SWITCH:
The USB pass-through on this unit is bi-directional, however not simultaneous, which means one unit
must be set to “HOST”, and the other to “DEVICE”
Switch to left (HOST), the USB HOST mode is enabled and connect a component such as a smart or
touch screen display; the USB ports on the Transmitting unit will be active to connect a keyboard/mouse;
Switch to right (DEVICE), the USB DEVICE mode is enabled to connect a keyboard/mouse, the
Transmitting unit must be set to “HOST” and connected to a component such as a PC or security NVR
Receiving Unit
8 9
6
7
3 5 4 1 2
10
11
14
12
15
13
16
19
17 18