www.vanco1.com
800-626-6445
8
EDID Management Continued
2. EDID invoking: There are five types of embedded EDID data. The chart below illustrated the detailed information of
the embedded EDID data:
Clear Operation
When you switch output channel, learn EDID data, or set EDID data, press “Clear” button to EXIT the operation before
you press “ENTER” to carry it on. When you press it, the Matrix Switcher will return to the previous status.
Force Carrier
a) Only if the IR receiver connected to HDBaseT receiver is with IR carrier, can the received IR signal be transferred
to IR OUT port of the Matrix Switcher.
b) Only if the IR receiver connected to the Matrix Switcher is with IR carrier, can the received IR signal be transferred
to IR OUT port of the Matrix Switcher.
If the IR receiver connected to HDBaseT receiver or the Matrix Switcher is without an IR carrier signal, send the
command “%0901.” to enter infrared carrier enforcing mode, and then IR signal can be transferred to IR OUT port.
Control Far-end Device Locally
Connect an IR receiver to IR IN on the Matrix Switcher, and use the IR Remote of far-end device to control the device
locally.
Connect an IR receiver with IR carrier to the IR IN port of the Matrix Switcher; users can control far-end output
displayer via its IR remote from local. In that case, the IR signal is transferred via twisted pair. Only the corresponding
IR OUT port can emit control signals to the remote display.
See the figure below:
Note: The IR receiver connected to IR IN must be with IR carrier
Number EDID Data
1
1080P LPCM
2
720P LPCM
3
3840 x 2160 LPCM
4
1080P Dolby/DTS
5
4096 x 2160 Dolby/DTS
