www.vanco1.com
800-626-6445
9
PC CONTROL
Installation
The matrix controller software is a green software. Just copy MatrixController.exe to your PC to control the
Matrix by RS232 COM port or TCP/IP to complete installation. (This may not be necessary in all applications.)
Preparation
•
Connect PC and Matrix by RS232 cable (headers of both sides of cable should be FEMALE) or TCP/
IP(local area network)
•
Power-up Matrix
•
Double click MatirxController.exe icon to run it
How to control Matrix
“General” page
1. Select RS232 COM or TCP mode
2. Select RS232 COM port
3. Click to connect or disconnect PC and Matrix
4. Select Matrix IP
5. Connect to Matrix IP
6. Search Matrix IP
7. Configure Matrix IP and MAC (see following
notes for further information)
8. Click to reset to the factory settings
9. Device information display area
10. Click to refresh device status: include device
information displayed in 9 area and Input/Output
Settings on “Matrix” page
11. Click to clear device information
12. Enable or disable Beep
