Vancare P-600, Техническое руководство

Страница: 4 / 36

Pneumatic Systems
The pneumatically operated functions up and down functions . A methodical check of the
pneumatic system starts from the hand control and works forward through the pneumatic
switches on the circuit board.
1. Hand control & Airline
•
Unplug the hand control airline from the lift and check for blockage of the airlines by
pressing each of the function buttons in turn. A small blast of air can be felt from the brass
pins at the end of the curly cord.
2. Air tubes
•
Re-attach the hand control airline to the lift. (The airline end plug has a cap that has a
raised ridge on one face. The raised cap ridge aligns with and slides over the ridge on the
grommet. Correct insertion can thus be verified by touch and by sight.)
Check to see that
the air tubes have been routed free and clear . If not routed properly, air tubes can get
trapped by wires, other lift components or the lift cover.
•
Check to see that the air tubes are correctly connected to the circuit board switches . The
two air tubes attached to the main board are color coded to correspond to the colored
stickers on the switches.
•
Next detach one air tube at a time from the circuit board. Check for leaks in an air tube by
pressing the function key corresponding to that air tube (the function is printed on the
PCB),
then pinch the open end of the air tube between two fingers, then release the
function button. The dome of the button should stay slightly compressed when the button
is released. Repeat for each air tube.
•
Air tubes are fragile . In detaching and re-attaching air tubes, do not press on the air tubes
with fingernails and be careful not to pierce the tubes with the connector pins.
If NO air leak is found then proceed to check the electrical system.
P-600 Technical Manual REV: 101316 Page 4