Vancare P-600, Техническое руководство

Страница: 15 / 36

ELECTRICAL INSTRUCTION SHEETS
E1 - Test and/or Replace Batteries
IMPORTANT NOTE: Sealed Lead Acid batteries must be handled with extreme care. A ny
leakage or warpage of the battery cover indicates battery failure. Replace immediately.
1. If the indicator light (LED) on the control panel indicates “Low Batt!” and an audible alarm
sounds, the batteries may not have sufficient power to operate the lift under load. Lift
should be returned to charger.
2. Using a voltmeter (set for DC volts 100 scale) measure the voltage across the RED and
Black wire terminals on the batteries. The reading should be greater than 27.5 VDC if fully
charged.
3. With the lift on charge, measure VDC. The reading should be between 27 to 30 VDC
indicating that the batteries are being charged. The lift should be left on charge for 30
minutes and retested. If the low battery indication still persists, the batteries should be
replaced.
4. Disconnect all wires from the batteries.
5. Using an Allen Key (M4) to remove two screws M4 x 12mm to remove the battery holding
bracket.
6. Ensure that an equivalent battery set is used to replace the original batteries (see
specifications).
7. Install the batteries and reinstall the battery holding brackets. Ensure that any wire
harnesses or airline tubing are loose, free of obstructions.
A blockage of the airlines will
cause hand control problems .
8. Connect the SEPARATE BLACK wire across the inside RED and BLACK battery
terminals. Reconnect the (+) and (-) wire harness wires to the matching terminals on the
batteries.
P-600 Technical Manual REV: 101316 Page 15