Secure the floor brackets to the side panels using M8x50 coach bolts,
M8 washers and M8 flange nuts. Tighten all fixings to 5Nm. Take care
not to damage the unit by over tightening.
04
IN8377 - 08 OF 12
Position the unit inside the vehicle in desired position.
Before proceeding, ensure that the rear doors can open and close
without any interference from the racking unit.
02
Prior to proceeding past this point please take the time to read through
the important note below.
01
If you are fixing a straight side panel, use floor bracket ME0918. If you
are fixing a tapered side panel, use floor bracket ME2058.
03
RECOMMENDED VEHICLE FLOOR FIXING METHOD (2 OF 3)
CAUTION
It is important that care is taken when drilling and fixing to your vehi-
cle.
You should note that it is the responsibility of the installer/s to ensure that when drilling holes
into your vehicle to take fixings, care must be taken to ensure that the fuel line, tyres, fuel tank,
wiring loom, exhaust, batteries, bodywork, and brake lines etc. are not damaged.
We advise customers to be extra cautious when fitting racking to electric or hybrid vehicles. For
these vehicles, we strongly recommend employing an experienced installer to ensure the
racking is properly affixed. Additionally, it is essential that you do not drill through the vehicle
flooring if there are batteries or wires present underneath.
If in doubt refer to the vehicle manufacturer’s dealership.
STRAIGHT
TAPERED
918
2058
?
