VALVER AIRBRUSH MANUAL EXTERNAL MIX EQUIPMENT, Инструкция по эксплуатации, Страница: 15 / 26

INSTRUCTIONS MANUAL
AIRBRUSH MANUAL EXTERNAL MIX EQUIPMENT
14
12. For the calibration adjustments follow the application product manufacturer
instructions. Repeat the calibration until getting the proportion as indicated by
the manufacturer. Register the regulation parameters shown on the pages 14-15-
16 of this manual, paragraph SETTING UP EXTERNAL MANUAL MIX.
13. Close the mixer air stopcock (14) , close the resin pump air stopcock (3) and
close the catalyser pump air stopcock (9) and recharge the deposits if
necessary.
14. Place the TRIMIX® mixer head (17) .
15. Open the mixer air stopcock (14) , open the resin pump air stopcock (3) and
open the catalyser pump air stopcock (9) and the spray pressure with the air
inlet spray pressure regulator (22). Adjust the spray pressure according to the
nature of the product and user requirements with the air gun control (7).
16. Adjust the pressure with the air gun control (7) or with the spread regulator.
The AIRBRUSH MANUAL EXTERNAL MIX EQUIPMENT is calibrated and ready for use.
Recommendations.
Clean the AIRBRUSH MANUAL EXTERNAL MIX EQUIPMENT thoroughly after use. Proper
maintenance will extend the equipment’s useful life.
Always use the solvent recommended by the product’s manufacturer for cleaning the
equipment.
The gun should be left immersed in cleaning solvent when not in use. The solvent must not
touch the air valve, in order that the nozzle remain clean.
Clean the outside of the TRIMIX® mixture head (17) frequently when working and leave the
gun (15) hanging vertically from the gun hook (20) when not in use. Avoid leaving the gun
(15) in a horizontal position, as this will lead to paint remains obstructing the catalyser
outlets.