VALVER AIRBRUSH MANUAL EXTERNAL MIX EQUIPMENT, Инструкция по эксплуатации

Страница: 11 / 26

INSTRUCTIONS MANUAL
AIRBRUSH MANUAL EXTERNAL MIX EQUIPMENT
10
To avoid any risk of fire or explosion:
x
NO SMOKING, next to the machine.
x
NON-sparking.
In the case of fire or explosion, use extinguishers - do not use water.
Extinguishers:
Class ABC: Dry powder, for LIQUIDS AND GASES
Class E: CO
2
for ELECTRICAL PARTS
3.2. Starting-up equipment.
1. Make sure that the Mixer air stopcock (14) , the Resin pump air stopcock (3)
(pressure tank only) and the Catalyser pump air stopcock (9) (pressure tank) are
closed.
2. Connect the air supply to the AIRBRUSH MANUAL EXTERNAL MIX EQUIPMENT’S
intake mixer air adaptor (13) , which supplies the pumps and the gun (15) .
3. Place the absorption (6) in the resin, in the case of dual-membrane units, or load the
tank, in the case of pressure tanks (closing correctly the Mixer air stopcock (14) .
4. Open the Resin pump air stopcock ( 3) in the pressure tank and adjust the pressure
of the resin pump (1) using the resin pump air control (4) .
5. Open the Catalyser pump air stopcock ( 9) in the pressure tank and adjust the
pressure of the catalyser pump (8) using the catalyser pump air control (10) .
6. The gun (15) pressure can be adjusted using the air gun control (7) .
7. Set the air gun control (7) to 0 bar to avoid splashing.
8. Open the resin valve (5) and adjust the resin pump air control (4) .
9. Place the gun tip (19) in the nozzle of the resin test tube (used for cleaning,
bleeding, recycling and calibration of mix percentage).
10. Squeeze the gun trigger (18) until resin begins to flow from the gun and the circuit
is loaded without air bubbles.
11. Close the resin valve (5) (dual membrane or pressure tank) before loading the
catalyser pump (8) .
12. Make sure that there is no pressure in the catalyser pump (8) (pressure tank), keep
the catalyser air pump bleed cock (9) and open the Catalyser pump bleed (11)
(pressure tank).
13. Remove the top from the catalyser pump (8) (pressure tank) and fill the catalyser.
14. Replace the pressure tank top, making sure that it is properly closed.
15. Close the Catalyser pump bleed (11) and open the Catalyser pump air stopcock
(9) (pressure tank).
16. Adjust the catalyser pump air control (10) (pressure tank).
17. Open the catalyser valve (12) .
18. Remove the TRIMIX® mixer head (17) from the gun (15) . Once the TRIMIX® mixer
head (17) has been removed from gun (15) , the equipment is ready for priming.
19. Place the TRIMIX® mixer head (17) in the nozzle of the catalyser test tube (used for
cleaning, bleeding, recycling and calibration of mix percentage) in order to recycle
and prime the catalyser circuit.