ValueJet MUTOH VJ-1938TX, Руководство для стартапов

Страница: 22 / 56

22 Assembling
[9] Connect the take-up motor cable (label: W_MOT) to the controller
board. (Enlarged image)
• A: Put the cable through the bottom clamp.
• B: Secure the earth wire to the earth terminal using one screw (Pan-head
screw with spring washer and flat washer M4 × 6).
Connect it to the second ground terminal from the top.
• C: Put the cable around the upper clamp once.
• D: Connect the cable connector to [J8] on the controller board.
2.
Wiring on the rear side
[1] Put the feeding motor cable (label: F_MOT) through the clamps on the
path.
• A: Untie the cable and put it through two clamps as shown in the image to
the left.
[2]
Put the feeding motor cable (label: F_MOT) through the clamps on the
path.
• A: Put the cable through two clamps on the rear tension unit.
• The tip of the cable will come out on the side with the waste fluid tank.
[3]
Put the feeding motor cable (label: F_MOT) through the grommet.
• A: Put the cable through one clamp on the rear tension unit.
• B: Put the cable through the grommet.
[4]
Connect the feeding motor cable (label: F_MOT) to the controller
board. (Enlarged image)
• A: Put the cable through the bottom clamp.
• B: Secure the earth wire to the earth terminal using one screw (Pan-head
screw with spring washer and flat washer M4 × 6).
Connect it to the first ground terminal from the top.
• C: Put the cable around the upper clamp once.
• D: Connect the cable connector to [J6] on the controller board.
D
A
B
C
A
A
A
A
A
B
D
A
B
C