www.valuehobby.com/stylus-sport-60.html
- 8 -
Step8. Use a 1.5mm (.06in) drill bit the drill the
mounting hole as shown.
Step9. Use four M2*8mm (.3in) self-tapping screws to
install the servo hatch to the wing.
Step10. Repeat the previous steps to finish the other
aileron servo installation.
Section 3: Aileron Linkage Installation
Required parts and hardware:
Aileron Servo pushrodΦ1.8*150mm (5.9in) 2pcs
Keeper 2pcs
Clevis 2pcs
Control horn 2pcs
Nut plate 2pcs
Philips roundhead screw M2*16mm (.6in) 4pcs
Step1. Thread the clevis into pushrod.
Step2. Attach the clevis to the control horn. Position
the control horn on the aileron. Use the pushrod wire
as a guide to align the horn to the servo arm. Position
the horn so the holes align with the hinge line. Use a
1.5mm (.06in) drill bit to drill the holes as shown.
