www.valuehobby.com/stylus-sport-60.html
- 12 -
Step7. Use a 2.5mm (.1in) drill bit to drill the hole in
the elevator as shown.
Step8. Insert three hinges into the slot in the leading
edge of the elevator.
Step9. Apply some glue into the slot.
Step10. Insert the end of the joiner into the elevator.
Slide the elevator and stabilizer together through the
hinges. Align the elevator tips with the stabilizer tips.
Once satisfied, use a felt-tipped pen to mark the
location for the other end of the joiner as shown.
Step11. Repeat step 7 to step 8 on the other elevator
panel.
Step12. Install the joiner on the other elevator panel.
Again slide the elevator and stabilizer together. Use
thin CA to saturate the hinges, including the top and
bottom of the hinges.
