www.valuehobby.com/p-51d-mustang-arf.html
17
Step3. Mark the location for engine mounting
screws. Drill the holes on the mark and install the
engine on the mounting using the screws provided
with the engine.
Step4. Use a pencil to mark the location for throttle
pushrod wire on the firewall.
Step5. Drill a hole through the firewall for the
throttle pushrod wire.
Step6. Slide the throttle pushrod wire through the
firewall.
Step7. Install the throttle servo. Electronically
adjust the throttle arm and servo arm to make
them move rightly.
Step8. Connect the pushrod wire to the servo arm.
Step9. The fuel tank can be assembled as a two line
system consisting of a vent (pressure) line to the
muffler and a carburetor line. Filling and emptying of
the tank would need to be done through the
carburetor line, or an optional fuel fill valve. The tank
can also be assembled as a three line system having a
vent line, carburetor line, and fill line. If install a fill
line, puncture the top of the stopper above the
sealed off fuel tube hole. The fill and carburetor lines
should extend out 13mm beyond the stopper and the
vent line should be bent upwards and left uncut.
With the tubes installed in the stopper, the stopper
plates loosely in place with the PM3x25mm screw to
hold the assembly together.
