Value Hobby Elite Model Aviator 75 ARF, Инструкция по эксплуатации

Страница: 12 / 20

www.valuehobby.com/aviator-75-arf.html
12
Step6. Remove the stabilizer and use a hobby knife
to remove the covering 1/16-inch inside the lines
just drawn.
Step7. Apply epoxy o the exposed area on both the
top and bottom of the stabilizer. Slide the stabilizer
back into position and double-check the alignment
of the stabilizer. Remove any excess epoxy using a
paper towel and rubbing alcohol.
Step8. Locate the fin and slide it into position.
Position the fin so it is fully forward in the slot in
the fuselage.
Trace the outline of the fuselage onto the fin, and
trace the outline of the fin onto the fuselage.
(Note: Check the alignment between the fin and
stabilizer. The fin must be 90-degrees to the
stabilizer to be in alignment. Sand the opening the
fuselage if necessary to get the perfect alignment.)
Step9. Remove the covering 1/16-inch below the
line drawn in the last step.
Step10. Remove the covering 1/16-inch inside the
lines drawn in the last step.
Step11. Apply the epoxy to the tab on the fin and
the area on the top of the fuselage where the
covering was removed. Position the fin in the slot
and check the alignment. Use the masking tape to
hold the fin in position until the epoxy fully cures.