Value Hobby Elite Model Aviator 75 ARF, Инструкция по эксплуатации

Страница: 11 / 20

www.valuehobby.com/aviator-75-arf.html
11
Section3. Tail Installation (including the tail wheel)
Step1. Use a hobby knife to remove the coverings
on the slots of the fuselage for the horizontal
stabilizer and fin.
(in order to insert the horizontal stabilizer into the
fuselage, you need to cut out part of the wood at
the end of the tail as shown.)
Step2. Slide the stabilizer into the slot in the
fuselage, with the leading edge push forward in the
slot. Center the stabilizer in the opening by
measuring the distance from the fuselage to each
tip. The stabilizer is aligned when both
measurements are identical.
Step3. Check the distance from each stabilizer tip
to each wing tip. These measurements must also
be equal.
Step4. The last alignment step is making sure the
wing and stabilize are parallel. If they are not,
lightly sand the opening in the fuselage for the
stabilizer until the stabilizer rests parallel to the
wing.
Step5. Use a felt-tipped pen to trace the outline of
the fuselage on the top and bottom of the
stabilizer.