Valtra 95, Руководство по обслуживанию, Страница: 19 / 41

17
Model Code Page
13. Maintenance
1. 11. 2000
130 1
95, 105, 115
X100-X120
Maintenance ValtraValmet
95, 105 and 115
X100, X110 and X120
N.B. Detailed maintenance instructions, see Operator's
Manual.
General
Correct maintenance at the right time is a basic condition
for reliable operation of the tractor. Maintenance costs are
small compared with any repair costs resulting from lack of
maintenance. The most important measures are those
which you carry out yourself and which include lubrication
and various checks and adjustments.
The service intervals shown apply for normal operating
conditions but in more severe conditions servicing should
be carried out more frequently.
General instructions concerning oil
checks and oil filling
- Always stop the engine before starting work
- Apply the parking brake to ensure the tractor cannot
move. If the ground is uneven the wheels should be
scotched
- Wash down the tractor first so that the work can be
done more easily and quickly.
- Always observe the utmost cleanliness in all maintenĆ
ance work. Thoroughly wipe off filler caps and plugs as
well as surrounding parts of the tractor before filling up
with fuel or oil.
- Inspect the oil and filters when changing. Large
amounts of dirt (e.g. heavily clogged filters) can point to a
fault which could cause extensive and costly repairs if not
corrected in time.
-When carrying out checks the tractor should stand on
level ground.
- Levels should be checked in the morning when the oil
is cold and has had time to run down to the bottom of the
unit concerned.
- When changing the oil, bear in mind that the oil can
be very hot when it drains from the tractor. Waste oil and
oil filters should be handled carefully and disposed of
properly
- After completion of the service work always replace all
safety covers etc.
Greasing lubricating points fitted with
grease nipples
- Always clean the grease nipples before applying the
grease gun.
- Apply grease through the nipples until clean grease
oozes out (unless otherwise instructed).
- Wipe away superfluous grease which has been
pressed out at the lubricating point.
- Preferably carry out lubrication with bearing points
and joints unloaded and with the bearings in different
positions.
Lubrication and maintenance schedule
All intervals are counted from zero hours on the hour recorder.
For example, 1000 hours service is carried out every 1000
(yearly), 2000 hours (every other year) etc. even if the guaranĆ
tee service has been carried out.
Example: The 1000 hour service contains all items mentioned
under 10 h/Daily, 50 h/once a week, 250 h, 500 h and 1000 h.