VALTIR EURO-ET END TERMINAL, Руководство по сборке изделия

Страница: 19 / 28

Valtir.com 18 Revision D February 2023
4. Slide the other end of the Cable Assembly (PN 3000G) through the hole in the Bearing Plate (PN
19258A) (see Figure 7).
5. Place a 25 mm f at washer (PN 3900G) and a 25 mm hex nut (PN 3910G) on the end of the
Cable Assembly (PN 3000G) that extends through the Bearing Plate (PN 19258A).
6. Tighten the 25 mm hex nuts (PN 3910G) on either end of the Cable Assembly (PN 3000G).
Restrain the Cable Assembly (PN 3000G) with vise grips at the end being tightened to avoid
twisting the Cable Assembly (PN 3000G). Confirm that the 25 mm hex nuts (PN 3910G) are tight
and the Cable Assembly (PN 3000G) is taut.
Note:
The Cable is considered taut when it does not deflect more than 25 mm when
pressure is applied by hand in an up or down direction.
Figure 7
Figure 8