VALTIR EURO-ET END TERMINAL, Руководство по сборке изделия

Страница: 15 / 28

Valtir.com 14 Revision D February 2023
Post 2
1. At Post No. 2 a tach the HBA Top Post 2 (PN 33877A) by aligning the holes of the post
plates (ears) on the Top and Bottom Posts.
Note:
The HBA Top Post Plates (Ears) can be placed Bottom Post Plates (Ears). on
either side of the HBA
2. Insert a 10 mm diameter x 51 mm hex head bolt (PN 6321G) through the 11 mm holes of the
post plates (ears) on the Top and Bottom Posts. The bolts should be positioned so the nuts are
on the inside of the post plates (ears) (see Figures 4 and 5).
3. Place a 10 mm flat washer (PN 4254G), and 10 mm lock washer (PN 4258G) under the 10
mm hex nut (PN 6405G) (see Figures 4 and 5).
4. Insert a 19 mm diameter x 64 mm hex head bolt (PN 3717G) through the 21 mm hole (on the
traffic side) of the post plates (ears) on the Top and Bottom Posts. The bolts should be positioned
so the nuts are on the inside of the post plates (ears) (see Figures 4 and 5).
5. Place a 19 mm flat washer (PN 3701G), and 19 mm lock washer (PN 4699G) under the 19
mm hex nut (PN 3704G) (see Figures 4 and 5).
Important:
There is no torque requirement for these bolts. They should be
tightened to a snug position. Do not over tighten these bolts
Important:
Do not attach the 19 mm diameter bolt on the field side until the
Angle Strut is ready to be attached.
Figure 4
Figure 5