17
15. CLEANING
All cleaning should be carried out when the heater is cold. Normally,
the heater should only need dusting. Any stains on the glass can be
removed with a non abrasive cleaner.
Abrasive cleaners should never be used on the glass.
15.1 Cleaning the inside of the window:
Open the case door fully. Remove the window unit by detaching the
knurled screws at sides near the top. Lift the window unit assembly up
to clear the locations at the bottom - see fig 7. In installation section of
this manual.
Be careful not to disturb the logs when removing the window. If they
are disturbed, refit them as described in the log installation section of
this manual.
Clean the window carefully by wiping with a soft cloth using a
suitable non abrasive cleaner in accordance with the makers
instructions. Replace the window unit. Locate its bottom edge in the
support channels at the firebox sides. Refit the two knurled screws and
tighten. Replace the window surround.
16 PERIODIC CHECKS
The venting system should be examined by a qualified agency
regularly. We suggest annually. The flow of combustion and
ventilation air must not be obstructed. A periodic visual check of the
pilot and burner flames should be made (see figs. 26 & 27)
17. CALLING FOR SERVICING
For owner
If you require any attention to your appliance, contact your supplier
quoting the model number. It is helpful if the appliance serial number
is also quoted. This will be found near the back of the case at the
bottom right side.
The servicing information on the following pages is for use
only for a qualified service engineer.
Fig. 26 Burner flames
Fig. 27 Pilot flame