99
Wall Switch
(optional)
ON
OFF
Manual On/Off Switch
Thermostatic
Remote Control
Thermostatic
Remote Control
Wall Switch
(optional)
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA CARD .
WHILE THE STOVE IS STILL HOT!
Let the stove
cool
fi
rst before touching it.
!
Owner’s Information
Locating Lighting, Operation and Rating
Information Card
The Lighting, Operation and Rating Information card
is located on the rear of the appliance casing.
To access the card, reach over the top of the stove
and pull the card out from its holder to read it. There is
important information on both sides of the card.
Servicing Your Stove
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance serial number can also be
quoted. This number is on the rating card, which is
attached to the unit. The replacement parts are shown
at the end of this manual. Please always quote the part
number and description when requesting spare parts.
Operating Your Stove
There are three ways to control your
fi
replace.
1. Thermostatic Remote Control;
2. Wall Switch;
3. Manual On/Off Switch.
The Thermostatic Remote Control can be
programmed to function automatically—
see pages 10–14.
The Wall Switch (optional) can be used to turn
on, off and to increase or decrease the
fl
ame
height—see 1265WSK—Wall Switch Kit.
NOTE:
The remote control in the AUTO
mode will override the wall switch.
The manual On/Off switch must
be ON for the
fi
replace to function.
It can be used to shut off the
fi
replace in case of emergency—
see above.
How to Turn Your Stove OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your stove.
Handset and Wall
Switch:
Press and
hold the OFF button
for a second (either on
the handset or the wall
switch).
ON
OFF
Manual On-Off Switch
Traditional Stoves—arched or square
fronted MFCS01 or MFCS02
Contemporary Stove
MFCS04
If the
fl
ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
Manual ON/OFF Switch:
Press the
O
button.
As well, familiarize yourself with the gas shut-off valve
location in your house. As indicated below, the gas is
running when the handle is parallel with the pipe. The
gas is off when the handle is perpendicular with the pipe.
How to Ensure Your Stove Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your stove will not turn on when you don’t
want it on.
First, ensure your stove is turned off—including
the pilot—and cold BEFORE going ahead.
• You can prevent your stove from lighting by pressing
the
O
button on the manual ON/OFF switch on the
gas valve—see image above.
• Alternately, remove all batteries from the receiver as
well as the battery from the handset.
Automatic Shut-Off
(in certain conditions)
Your stove’s remote control is equipped with an
automatic shut-off mechanism which is activated in
certain conditions. See page 14 in the
Remote Control
Operation
section for a description of this feature.
ON: parallel to pipe
OFF:
perpendicular
to pipe
OWNER’S
INFORMATION
Содержание MADRONA MF28JN
Страница 44: ......
