Manual ON/OFF Switch
OFF
ON
Fireplace Control Devices
There are three ways to control your fi replace.
1. Thermostatic Remote Control can be programmed
to function automatically—see pages 8–11;
2. Wall Switch (optional) turns fi re on, off and controls
fl ame height—see 1265WSK or RBWSK—Wall
Switch Kit;
NOTE:
The remote control in the AUTO mode will
override the wall switch.
3. Manual On/Off Switch on gas valve—must be ON
for the fi replace to function. It can be used to shut
off the fi replace in case of emergency—see below.
How to Turn Your Fireplace ON
Press and hold button(s) until a short beep confi rms the
start sequence has begun; release buttons.
Continuing beeps confi rm the ignition is in process.
When the pilot is lit, the gas fl ows—see
Using Your
Remote Control
section for more information.
How to Turn Your Fireplace OFF
(including pilot)
Press and hold the OFF button for a second.
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
In the unlikely event that you cannot turn off your
fi replace with the remote control handset, use the
wall switch (if installed); if the wall switch malfunctions
and will not turn off the fi replace, wait 6 hours and the
fi replace will automatically go to pilot. You can then
access the controls inside your fi replace. Alternately,
turn off gas supply. In all cases, call your dealer for
service assistance.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your fi replace will not turn on when you
don’t want it on.
• You can prevent your fi replace from lighting by
pressing the
O
button on the manual ON/OFF
switch on the gas valve.
• Alternately, you can remove all batteries from the
receiver as well as the battery from the handset.
Automatic Shut-Off
(in certain conditions)
Your fi replace’s remote control is equipped with an
automatic shut-off mechanism which is activated
in certain conditions. See page 11 in the
Using the
Remote Control
section for a description of this feature.
WARNING
RISKS OF SEVERE BURNS! SURFACES OF
THE FIREPLACE ARE VERY HOT DURING
OPERATION!
Be very careful and wear gloves to
access controls.
!
Wall Switch
(optional)
Remote control
handset
Wall Switch
(optional)
Remote control
handset
ON: parallel to pipe
OFF:
perpendicular
to pipe
Wall Switch
(optional)
Manual On/
Off Switch
Thermostatic Remote
Control
Operating Your Fireplace
OWNER’S
INFORMATION
7
Содержание Legend G4 Series
Страница 46: ......
