Valor Legend G4 Series, Инструкция по установке и эксплуатации

Страница: 10 / 48

Using the Remote Control
Circulating Fan Operation
(if equipped)
Circulating fan has 4 speed levels from
low to high (1 to 4 bars).
Press SET to scroll to . Fan and
level icons ȵ ash.
To set speed, press ȵ ame buttons:
= increases speed.
= decreases speed and
turns OFF fan when all bars disappear.
Note: 8 seconds after the fan is set, handset goes
automatically in temperature control mode. Fan
starts 4 minutes after gas opens (from OFF or
pilot) at maximum speed then goes to displayed
level after 10 seconds. Fan stops 10 minutes after
gas is OFF or at pilot.
Setting ON / OFF Temperatures
Setting “DAYTIME” temperature.
Default Settings:
TEMP
23 °C/74 °F
Press SET to scroll to
TEMP
Hold SET button until TEMP ȵ ashes.
To set Daytime Temperature:
= increases temperature.
= decreases temperature.
Press or wait to complete setting.
Setting “NIGHT TIME SETBACK” temperature.
Default Settings:
TEMP
“--” (OFF)
Press SET to scroll to
TEMP
Hold SET button until TEMP ȵ ashes.
To set Night Time Temperature:
= increases temperature.
= decreases temperature.
Press or wait to complete setting.
Setting Program Timers
You can program two periods of time between 12 am
and 11:50 pm in each 24-hour cycle.
Programs P1 and P2 must be set in the following order
during a 24-hour cycle:
P1
,
P1
,
P2
and
P2
.
= beginning of program period, turns ON
= end of program period, turns OFF
Default Settings:
Program 1:
P1
06:00 am
P1
08:00 am
Program 2:
P2
11:50 pm
P2
11:50 pm
Press SET to scroll to
TIMER
.
Setting P1 ON time.
Hold SET button until
P1
is displayed and time
ȵ ashes.
To set ON time:
= hour
= minutes
Press or wait to complete setting.
Setting P1 OFF time.
Hold SET button until
P1
is displayed
and time ȵ ashes.
To set ON time:
= hour
= minutes
Press or wait to complete setting.
If
P1
=
P1
or
P2
=
P2
,
programming is cancelled.
To keep
ȴ replace ON all night, set
P2
at
11:50 am and
P1
at 12:00 am.
If you want to program only one period,
program
P1
and
P1
with desired times
then
P2
and
P2
with the same time
as
P1
.
OWNER’S
INFORMATION
10