Owner’s Information
6.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
7.
Replace the front or trim with the barrier screen
attached.
Checking pilot and burner
fl
ames
A periodic check of the pilot and burner
fl
ames should
be made. Check after the
fi
re has been on for at least
30 minutes. The pilot
fl
ame must cover the tip of the
thermocouple probe. The main burner
fl
ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and free
from combustible materials, gasoline and other
fl
ammable
vapors and liquids.
Inspect the vent terminal outdoors regularly to make sure
that snow, trees, bushes, leaves, or other objects do not
obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Replacing Batteries
Low battery signal: see page 13.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —
see instructions
next page.
The appliance uses four 1.5 V AA
alkaline
batteries for
its remote control receiver and one 9 V
alkaline
battery
for its handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life. Should the batteries
loose power, the control may be operated by manually
turning the control knob at the valve or by turning off the
valve at the switch.
To replace the batteries in the remote control
receiver
:
1. The receiver is located to the left of the valve and it
is retained to the
fi
rebox by a
Velcro
tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace the batteries with 4 AA
alkaline
batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
it attaches to the
Velcro
tab.
Hot Glass Plate
Rock fuel bed
A black discoloration may form over time at the front
bottom of the 6-rock original fuel bed; this deposit
can be burned off by running the
fi
replace on a low
to medium setting
fi
re for 30 to 45 minutes. This
discoloration is unavoidable and will re-form again.
Correct Flame
Picture—Rocks
Thermocouple
probe must be
in flame
Correct Flame
Picture—Logs
Pilot Flame can be seen
between left front and top logs
left of
fi
rst rock
Pilot
fl
ame
Thermocouple
probe must be
in
fl
ame
WARNING
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the
fi
replace front after
maintenance.
!
CAUTION
DO NOT USE
a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the
fi
replace cool
fi
rst before touching it.
WARNING
!
7
OWNER’S
INFORMATION
