Valor Legend 736XN, Инструкция по установке и эксплуатации

Страница: 5 / 14

5
1.6 FLOOR
The floor in the fireplace recess must be sufficiently flat and
level to support the appliance satisfactorily. Some fireplace
constructions have a well in the floor at the back, which may
need to be filled in. Do not place the appliance on carpeting,
vinyl or other soft-surface floor coverings. Install only on hard
surfaced materials. We recommend that a hard surfaced hearth
area be maintained at least 12” in front of the fireplace for
both aesthetic and maintenance purposes. This may be
finished in brick, ceramic tile, marble etc. Raising the hearth
slightly will help to minimize dust and lint accumulation
under the unit.
If the appliance is installed directly on any combustible
material other than wood flooring, the appliance shall be
installed on a metal or wood panel extending the full width
and depth of the appliance.
1.7 PACK CONTENTS
The pack contains:
1
Appliance fitted with front unit.
4 Ceramic logs.
1 Pair of ceramic firebox side walls.
1 Ceramic firebox back wall.
1 Supply line elbow connector.
Take care when removing the contents from the packaging to
prevent damage.
Check that all the contents are in the pack and are undamaged.
2. INSTALLING IN AN EXISTING
FIREPLACE
2.1 PRE-INSTALLATION PREPARATION
2.1.1 Closing Large Fireplace Openings
This appliance is suitable for fireplace openings from 21” to
25
1
/
4
” high and 31
1
/
4
” to 39” wide. For infilling larger
fireplace openings the fireplace opening may be reduced or
the outer surround plate extended provided non-combustible
materials are used.
2.1.2 Remove Inner Front Unit
Unhook the inner front unit and lift clear (see figure 5). Put
the unit in a safe place.
2.1.3 Remove Window and Logs
See figure 6.
1.
Detach the window unit by removing the two knurled
screws situated at the bottom corners of the unit.
2. Lift the window unit up and forwards to unhook the
top. Put the window in a safe place.
3. Take the ceramic logs out of the firebox and store in
a safe place.
2.1.4 Remove the Front Frame
Detach the front frame by unscrewing two screws each side.
The lower screws are accessible when the bottom grill is
opened. See figure 7.
2.1.5 Remove the Vent Connection Unit
Detach the vent connection unit from the top of the appliance
case by removing the screw at the front and lifting the unit
clear. See figure 8.
Fig. 5 Inner Front Unit Removal
Fig. 6 Window Removal
Figure 7. Front Unit Removal
Figure 8. Vent Connector Removal