11
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn
by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.
LIGHTING INSTRUCTIONS
1.
STOP! Read the safety information above.
2
set the thermostat to its lowest setting (#1)
3.
Turn the control knob clockwise to OFF
NOTE: The knob cannot be turned from IGN to OFF unless it is pushed in partially. Do not force.
4
.
Wait five (5) minutes to clear out any gas, then smell for gas, including near the floor. If you smell gas,
STOP! Follow “B” in the safety information above. If you don’t smell gas, go to the next step.
5.
Find the pilot. It is at the right side of the firebox.
6.
Push in and turn the control knob counterclockwise until resistance is felt just before the “IGN”
position.
7.
Keep pushed in for a few seconds to allow gas to flow then, keeping knob depressed, turn to “ign” to light
pilot. Hold knob in for a further 5 seconds then release. The knob should pop back out. Pilot should remain
lit. If pilot goes out repeat steps 3 through 7. If pilot does not light at all during a few attempts, try lighting
with a long match as described below.
•
If knob does not pop out when released, stop and immediately call your service technician or gas
supplier
.
•
If pilot lights but will not stay lit after several tries, turn the gas control knob to “OFF” and call your
service technician or gas supplier.
8.
When pilot is lit, partially depress the knob and turn to “MAX” position.
•
Do not leave knob set between “IGN” and “MAX”.
9.
Replace control access panel
10.
Set thermostat to desired setting.
Match Lighting: Apply a long match to the pilot while control knob is pushed in and at the “IGN” position.
TO TURN OFF GAS TO APPLIANCE
1.
Set the thermostat to its lowest setting (#1)
2.
Push in control knob slightly and turn clockwise to “OFF”. Do not force.
Содержание Legend 736XN
Страница 13: ...13 Figure 27 Burner Module Removal...
