next symbol show a flashing sun symbol- press and release
SET
- as Mo is flashing
press and release
SET
again, enter the next time of 09:00- press and release
SET
-
change the flashing sun symbol to a flashing moon symbol by pressing and releasing
the + and – buttons then press and release
SET
again to store the moon setting
continue this until you have entered each time and temperature change required for
each day.
To put the fire into thermostat timer mode press and release the
MODE
button until
the thermostat and timer symbols are displayed on the display at the top. Press and
release the
SET
button and the control will now run the timed program set up in the
memory. To adjust any time setting in the memory re-enter the timer program setup
mode (by pressing
SET
and then
MODE
as described above). Then press set to
make the time flash. Now holding the + button advances the display to the next
setting and so on throughout the program. Amend the appropriate setting and when
finished do a long press of the
SET
button to exit the program mode.
To rest the whole timer program in the memory: - Hold handset- press set- press
mode until
SETUP
is flashing- press
SET
to enter SETUP- press
SET
about 8 times
until
CP0
is flashing on the display use the + and – buttons to change the display to
CP1
– press SET – press
SET
again and the display will return to standby Manual
mode and the timer setting have been completely removed for the timer memory.
3l - Paging feature built into remote handset to find its location
If you have misplaced the handset (and it is in range of the fire), you can page it by
pressing the + button only on the fire control for around 5 seconds. The handset will
flash and make a noise to help you to locate it. Once you pick up the TESC it knows
you hold it and so the sound stops. The flashing and sound will last for 60 seconds
each time the handset is paged as described. If not found in 60 seconds, page again
and so on.
NOTE: PRESS “+” Button ONLY,
NOT “+” and “- ‘Together as you will accidentally
break the handset pairing and have to reset handset to factory state and pair again
(see other Page 25 of the booklet if this happens).
3m - Advanced settings Menu
In the event that you may wish to change the other pre-set settings of the control
features.
Do not do a long press and hold above but a normal short press and release will take
you into the advanced settings area.
Advanced settings options are: -
Back light –
A = Automatic (default setting). The back light comes on in the dark but not in
the light.
0 = Light never comes on.
1 = Light comes on whenever handset is unlocked.
Display contrast – 8 levels from 0 to 7 (default level 4).
Page 51
©
GDC Group Ltd. SEPT 2018
OWNER GUIDE