Valor GV60CKO, Руководство по установке

Страница: 2 / 28

2
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the receiver or
the handset! This could cause a short circuit to the
receiver.
CAUTION
To avoid short-circuit to the receiver,
position the
antenna
so that it
DOES
NOT TOUCH the ignition wire.
Ignition Wire Connection
(spade type connector)
Be careful when removing and
reinstallaing: not to bend or
break the spade connector
Ignition
Wire
Antenna
Replace the existing receiver
Locate the existing receiver on the appliance. The
receiver is held in place by
Velcro on most appliances.
Refer to the appliance’s manual if necessary.
1. Detach the receiver and pull it out of the appliance
to disconnect it. Be careful not to pull too hard
as you could damage the wire connections,
particularly the ignition wire connection.
2. Remove all the wires connected to the receiver and
set the receiver aside.
3. Connect the outdoor receiver (G6R-R3AMC) to the
existing wiring.
DO NOT INSTALL BATTERIES
YET! Ensure no batteries are installed in the
RBWSK if used.
Connections on the outdoor
receiver are identical to the existing receiver. See
diagram below.
Valve Wire
Harness
Red
Yellow
Wall Switch
Harness
RBWSK—
Remote Battery
Wall Switch kit
power connector
IMPORTANT: The
connection can only be
done one way. Do not
force it or damage the
pins on the receiver
box!
4. Install and connect the wall switch supplied with
the appliance to the receiver following instructions
provided with the appliance’s installation manual;
if the appliance is not supplied with a wall switch,
connect the RBWSK—Remote battery and wall
switch kit (supplied separately) to the outdoor
receiver—see installation instructions supplied with
the kit.
5. Insert 4 AA alkaline batteries into the outdoor
receiver or the RBWSK kit only after all connections
are completed.
6. Test the operation of the wall switch—see
appliance’s or wall switch kit instructions manual.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER OR RBWSK
until the
wires are connected to the burner control unit as
short-circuit could result in the destruction of the
electrical components
.
Take the switch wire and plug it into the receiver’s
connection slot as indicated.
Kit Contents
1 GV60 outdoor receiver with conformal coating—
to resist weather—part no. 4005111
1 Overlay conversion label—part no. 4006081
1 Outdoor Lighting Instructions card—part no. 4005169
G6R-R3AMC—
Outdoor receiver
Conversion label and
Lighting Instructions