2
Remote Control Operation
Radio Frequency
315 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules
and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: Before using the remote control system for
the fi rst time,
the receiver and the handset must be
synchronized. See the section
Remote Control Initial Set-
up
on the previous page of this manual.
IMPORTANT:
BEFORE YOU BEGIN, please note that
on this system, the settings of time, temperature and
automatic ON/OFF can only be programmed when
the function display is fl ashing. Be patient when
programming as it can take a few seconds to set.
Note: In the TEMP or TIMER modes, the remote handset
senses the room temperature and adjusts the fl ame
accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the fi replace.
Do not leave the handset on the mantel or hearth.
SET
(scrolls
through
modes and
settings)
OFF
(returns
to set mode,
turns the burner
and the pilot off )
Large flame
button (flames
up, sets hours,
temperature)
Small flame
button (flames
down and off,
sets minutes,
temperature)
Current
temperature
(F or C)
Current time
(12 or 24 hour clock)
Modes (Manual,
Temperature, Timer)
Handset
sensor
Battery status
Current
programmed
period (Timer)
Period
start or end
(Temp, Timer)
Fan setting (if used)
When the pilot is off , it will take 2
minutes before it can be lit again.
TO TURN ON APPLIANCE
TO TURN OFF APPLIANCE
FLAME HEIGHT ADJUSTMENT
On the valve, turn MAN knob on the ON, full
counterclockwise position.
Place ON/OFF switch (if equipped) in I (ON position).
STANDBY MODE (Pilot Flame)
Press and hold (small fl ame) to set appliance at
pilot fl ame.
Simultaneously press the OFF and
(large fl ame) buttons until a short
beep confi rms the start sequence has
begun; release buttons.
Continuing beeps confi rm the ignition is
in process.
Once pilot ignition is confi rmed, there is
main gas fl ow.
After main burner ignition the handset
will automatically go into manual (MAN)
control mode.
Press OFF button.
When the pilot is off , it will take 2
minutes before it can be lit again.
In standby mode: Press and hold
(large fl ame) button to increase
fl ame height.
CAUTION
When pilot ignition is confi rmed, motor turns
automatically to maximum fl ame height.