4
Figure 2
IMPORTANT
: Before using the fire for the first time please check that the
flame effect drum is correctly positioned. The drum can sometimes
become dislodged during transit.
To check:
•
Lift out the plastic fuel support
•
You will see two lamp bulbs with the drum above them.
•
The drum has a spring loaded axle at its right hand end. This should
fit into the hollow recess in the black plastic holder. See figure 1a.
•
If the drum is out of position simply push it back into the recess.
•
Replace the plastic fuel support.
Close the stove doors.
Route the mains cable to the socket. Plug in and switch on at the socket.
Open the bag containing the coals. Using the plastic glove supplied, place the coals on and in front of the
plastic fuel support. Arrange the coals to your liking. You do not have to use all the coals.
Operation
Never cover the stove or obstruct the fan outlet grille under the stove. This could cause
overheating and a consequent risk of fire.
The controls are near the top of the right side of the stove.
Main on – off switch
. In the on (
) position the flame effect light is on.
Half Heat switch (1kW)
. Blows hot air. The flame effect light is on.
Full heat switch (2kW)
. Blows hot air. The flame effect light is on.
Safety cut–out
Your stove incorporates a thermal cut-out in the heating element to prevent damage due to overheating. The
cut-out will operate if the fan air outlet is obstructed. If this happens, switch the stove off, disconnect the
mains plug from the socket and allow the stove to cool then remove the obstruction if possible. If the
obstruction can not be removed or if the cut-out operates for some other reason, leave the stove switched
off and contact your service agent or other qualified electrician.
Maintenance
Always disconnect the stove from the electricity supply socket and allow the stove to cool before
commencing any maintenance.
Lamp Replacement
The lamps fitted to this stove are long life types but, due to the indeterminate life span
and ease of replacement, they are specifically excluded from the guarantee
Open the stove door.
Lift out the coals and the fuel support and place on a sheet of paper. See figure 2.
Remove the lamp by carefully rotating it anti-clockwise until it comes out of the holder.
Replace with a
60W clear Edison screw
lamp. Do not use opaque or coloured lamps.
Refit the fuel support and coals.
Cleaning
The stove surfaces and door glass should only need occasional wiping with a soft dry cloth. Do not use
polishes or abrasive cleaners.
Use a vacuum cleaner with a soft brush attachment occasionally to remove any dust or fluff from the fan air
outlet grille underneath the stove.
Figure 1a
