Valor 780JN, Инструкция по установке и эксплуатации

Страница: 12 / 46

•• - Nighttime Setback
Temperature Mode
(Appliance
must be in standby mode; pilot
ignited)
- The room temperature
is measured and compared to the
Nighttime Setback temperature.
The
 ame height is then automati-
cally adjusted to achieve the Night-
time Setback Temperature.
•• - Timer Mode (Appliance
must be in standby mode; pilot
ignited)
- The timers P1 and P2
(Program 1, Program 2) each can
be programmed to go ON and OFF
at speci
 c times. For instructions
see Timer Programming Mode.
•• Brie  y press SET button to scroll
to (fan) mode. Fan and Level
icons
 ash.
•• Press (large  ame) button to
switch ON and increase fan speed.
•• Press (small  ame) button
to decrease fan speed. To turn
OFF fan, press (small
 ame)
button until all 4 speed level bars
disappear.
NOTE: The display shows the set temperature every
30 seconds.
NOTE: 8 seconds after the fan has been set, the
handset will automatically go into temperature
control mode. The fan starts 4 minutes after
the gas opens (from OFF or from pilot) at
maximum speed and goes to the displayed
level after 10 seconds. The fan stops 10
minutes after the gas is OFF or at pilot.
-
Circulating Fan
- The circulating fan has
4 speed levels from low (1 bar) to high (4 bars).
CIRCULATING FAN OPERATION
(if equipped)
Tip
Set the different parameters when they are  ashing.
TEMP
TIMER
SETTING THE ON / OFF TEMPERATURES
•• Brie  y press SET button to scroll to
TEMP (sun) mode. Hold
the SET button until the TEMP
 ashes.
•• Press (large  ame) button
to increase the Daytime Set
Temperature.
•• Press (small  ame) button
to decrease Daytime Set
Temperature.
•• Press OFF or simply wait to
complete programming.
SETTING THE “DAYTIME” TEMPERATURE
Default Settings:
(sun),
23ºC / 74ºF
TEMP
TEMP
Remote Control Operation
12
OWNER’S
INFORMATION