Valor 700, Руководство по эксплуатации, Страница: 4 / 7

4
Double burner ON/
OFF commands
diagram at the rear
of the handset
••
- Nighttime Setback
Temperature Mode
(Appliance
must be in standby mode; pilot
ignited)
- The room temperature
is measured and compared to the
Nighttime Setback temperature.
The
 ame height is then automati-
cally adjusted to achieve the Night-
time Setback Temperature.
••
- Timer Mode (Appliance
must be in standby mode; pilot
ignited)
- The timers P1 and P2
(Program 1, Program 2) each can
be programmed to go ON and OFF
at speci
 c times. For instructions
see Timer Programming Mode.
••
Brie  y press SET button to scroll
to (fan) mode. Fan and Level
icons
 ash.
••
Press (large  ame) button to
switch ON and increase fan speed.
••
Press (small  ame) button
to decrease fan speed. To turn
OFF fan, press (small
 ame)
button until all 4 speed level bars
disappear.
NOTE: The display shows the set temperature every
30 seconds.
NOTE: 8 seconds after the fan has been set, the
handset will automatically go into temperature
control mode. The fan starts 4 minutes after
the gas opens (from OFF or from pilot) at
maximum speed and goes to the displayed
level after 10 seconds. The fan stops 10
minutes after the gas is OFF or at pilot.
NOTE: The function AUX is
blocked in programming
mode (TIMER, P1 or P2)
when the Nighttime Set-
back Temperature
is set at
--
.
NOTE: The rear part of the double burner cannot be ac-
tivated manually: it can only function with the re-
mote control. However, if the battery runs down,
the rear part of the burner will run according
its the last operating position. During normal
operation when lit with the remote control, both
parts of the burner turn on regardless of the set-
ting during the last use of the
 replace.
- Circulating Fan - The circulating fan has 4
speed levels from low (1 bar) to high (4 bars).
Rear burner
OFF
Rear burner
ON
CIRCULATING FAN OPERATION
(if equipped)
••
Upon ignition both parts of the
burner are ON.
••
Simultaneously press SET and
(small
 ame) buttons to switch
the rear burner OFF. Printed
instructions are on the handset’’s
battery cover.
••
Simultaneously press SET and
(large
 ame) buttons to switch rear
part of the burner on. The AUX
symbol on the handset display
indicates that the rear part of the
burner is ON.
TO OPEN AND CLOSE DOUBLE BURNER
(785  replace models only)
Tip
Set the different parameters when they are  ashing.
TEMP
TEMP
TIMER