24
12.
CERAMIC FUEL BED INSTALLATION
12.1.
Ceramic Walls
Installation
1.
Locate the ceramic rear wall
in the channel at back of the
firebox and flat against the back of
the firebox. See figure 36.
2.
Locate the sidewalls against
the sides of the firebox. Make sure
that they are behind the raised
edges of the burner module base at
the back corners. See figure 37.
3.
Remove two screws from
under the top front of the firebox.
Using these screws fit the port
cover. See figure 38.
12.2.
Ceramic Logs
Installation
1.
Place the ash bed in
position. The projections
at the front of the ash bed
locate against the sloping
metal stops immediately
behind the burner. See
figure 39.
2.
Place the rear log
in position locating the
two top projections in the
ash bed into the holes in
the rear log. See figure 40.
3.
Place the front log
at the front of the firebox
as shown in figure 41.
4.
Place the right side
center log in position
locating it on the two
locating pins on the left
hand side of the ash bed
with its “nose” resting at
the center of the ash bed
as shown in figure 42.
5.
Place the right side center log in position
locating on the two pins on the right hand side of the
ash bed with its nose” resting at the center of the ash
bed as shown in figure 43.
6.
Place “branch end” of the cross log on the pin
located on the center of the rear log and the other end in
the locating pocket on the left side of the front log as
shown in figure 44.
Figure 40 Rear log
Figure 39 Ash bed
Figure 38 Port cover
Figure 37 Side walls
Figure 36 Rear wall
Figure 43 right centre log
Figure 44 Cross log
Figure 41 Front log
Figure 42 left centre log
Содержание 535XAN
Страница 15: ...15...
