Valor 347 Helmsley, Инструкция по установке и эксплуатации

Страница: 27 / 44

-
Replace the dress guard. Locate the bottom of the dress guard in the two holes in
the bottom panel apron. Push the guard back so that the two spring projections at the
top of the guard engage in the slots under the front decorative canopy.
11.2 To remove the fascia.
1. Remove the control knob by pulling clear of the gas tap spindle.
2. Remove the two fascia retaining screws located at the rear of the fascia near the
bottom.
3. Lift the fascia up and forward to clear the rear top location.
4. Replace in the reverse order. Make sure that the channel near the top of the rear
of the fascia locates fully into the wings of the engine back panel (See figure 12) in
the installation section.
Make sure that the radiants are not dislodged when refitting the fascia.
11.3 To replace the pilot unit.
1. Remove the fascia as section 11.2 above.
2. Disconnect the thermocouple connection at the bottom of the gas tap.
3. Disconnect the pilot pipe from the gas tap. It is the upper connection at the right
side of the tap.
4. Remove the first screw securing the dust cage to the pilot unit & burner bracket.
Carefully remove the dust cage and place aside. Remove the second screw securing
the pilot unit to the burner bracket.
5. Disconnect the electrode lead from below the pilot electrode.
6. Carefully remove the pilot unit together with the pilot pipe then disconnect the pipe
from the pilot unit.
7. Replace in the reverse order.
Note: 1 The pilot unit must be replaced as a whole assembly. Its individual
components are not separately replaceable.
2. Once removed, ensure that the dust cage is cleaned before refitting. Make
sure that it locates squarely onto the pilot unit without any gaps between the
cage edges and the pilot unit.
Page 27
©
GDC Group Limited 2014.
INSTALLER GUIDE