Valor 347 Helmsley, Инструкция по установке и эксплуатации

Страница: 17 / 44

accordance with BS 5440 Part 1 to ensure that the products of combustion can be
safely dispersed into the outside atmosphere. Where the appliance is connected
to an unlined brick chimney it is generally unnecessary for the chimney pot to be
replaced or for a terminal to be fitted unless the flue has a diameter smaller than
170mm.
5. PRE-INSTALLATION PREPARATION
5.1 Unpacking.
This appliance is supplied completely assembled except for:-
-
4 radiants which are in a cardboard pack inside the firebox.
-
The closure plate.
-
Literature pack.
-
An olive & olive nut for gas line connection.
Remove all the items carefully to prevent damage. Some items may be contained in
the packaging fitments - Examine the packaging carefully before discarding. Check
that all the items are present and undamaged.
5.2 Appliance preparation.
1. Stand the fire upright.
2. Remove the two transit screws from near the top
of the back panel wings (See figure 5).
3. Remove the control knob by pulling clear of the
gas tap spindle.
4. Remove the two fascia retaining screws located at
the front of the fascia near the bottom corners.
5. Lift the fascia up and forward to clear the rear top
location. Store in a safe place.
6. Remove the radiant pack by gently lifting and
pulling forward from the bottom.
7. Remove the cardboard strip from the top of the
burner area.
8. Remove any protective film from all the bright trims.
9. If the fire is fitted to a recessed fireplace, an extension flue spigot up to a
maximum total length of 125mm may be used. The extension must be a tight fit over
the flue spigot and be secured by two self tapping screws. Note the minimum
clearance required as shown in figure 4.
Page 17
©
GDC Group Limited 2014.
INSTALLER GUIDE
Figure 5. Transit screws.