will only fit to the correct motor terminals.
17.6 To replace the burner.
1.
Remove the burner unit (See section
17.3).
2.
Support the elbow injector and
unscrew the injector nut.
3.
Remove the two screws from the
burner clamping plate (See figure 39)
4.
Lift the right hand side of the burner,
slide it to the right and lift clear
5.
Refit in reverse order.
17.7 To remove the main burner
injector.
1.
Remove the burner (See section 17.6).
2.
Remove the burner clamping screw
(See figure 40)
3.
Unscrew the injector from the burner
4.
Refit in the reverse order.
17.8 To remove the appliance from the
fireplace.
1.
Remove the burner unit - See section 17.3.
2.
If the fire retention is as method 1 (See section
9.1 of installation instructions), remove the screws.
If the fire retention is as method 2 (See section 9.2
of this guide), slacken the hexagonal adjusters on
the cable retainers and unscrew the thumb screw
to release the cables.
3.
Refit as described in the relevant installation
sections. Make sure gas soundness, sealing,
spillage test and performance are satisfactory.
Page 37
©
Baxi Heating U.K. Limited 2009.
Figure 40. Main burner
injector removal
Figure 39. Removal of burner
Figure 38. Gas valve (Viewed from rear
with burner turned over)
INSTALLER GUIDE