Vallox 096 MC R, Эксплуатационные, технические и инструкции по обслуживанию

Страница: 10 / 12

10
Vallox
096
MC
© VALLOX • We reserve the right to make changes without prior notice.
What the units include can vary depending on the sales area.
MOUNTING
4
332
544
600
600
5
395
8
15
15
630
J
Ceiling mounting with ceiling mounting plate
(option)
An optional ceiling mounting plate can be used with the unit. The
ceiling mounting plate is attached to the ceiling with M8 thread
bars. Fix the bars so that they stand the weight of the unit. The ceiling
mounting plate has to be fi xed horizontally in order to ensure that
the unit will be straight. The outdoor and exhaust air duct must be in-
sulated against condensation, also between the unit and the ceiling
mounting plate. The ceiling mounting plate is mounted horizontally
level, and it has to be attached so that there is a space of circa 4 mm
between the back edge of the ceiling mounting plate and the wall.
The ventilation unit is then as close to the wall as possible. Minimum
distance between the bottom edge of the ceiling mounting plate and
the ceiling of the room is 50 mm.
The ceiling mounting plate is fi xed to the ceiling with M8 thread
bars. After the thread bars have been fastened to the ceiling, fi rst
turn the nuts into the thread bars and lift the ceiling mounting plate in
place. Then push a rubber damper and washer to each thread bar,
all the way into the cup of the plate, and turn the nut. Shorten the
lower ends of the thread bars so that they will be at no more than
25 mm from the lower surface of the ceiling mounting plate.
Mounting of ventilation unit to ceiling mounting plate
Mount the locking washers (J) delivered with the ceiling mounting
plate in place with the 4 screws. Lift the unit and take the kables
through the opening in the ceiling mounting plate. Put the locking
devices attached to the top of the ventilation unit at the openings in
the ceiling mounting plate and lift upwards. Make sure that the unit
is locked in place.
Check that the condensing water insulation between the unit and the
ceiling mounting plate is in place in the exhaust and outdoor air duct.
The unit can be detached from the ceiling mounting plate by pul-
ling the spring-loaded moulding to the direction shown by the arrow
(more detailed information provided with the ceiling mounting plate).
Attic fl oor penetration plate
(option)
When an attic fl oor penetration plate is used, the tightness of the
vapour barrier has to be ensured.
Minimum distance to the
back wall is 5 mm.
Minimum distance to side
walls is 15 mm.
Minimum distance between the bottom edge
of the ceiling mounting plate and the ceiling
of the room is 50 mm.
Minimum distance to the back wall is 4 mm.